Evercoss M40 Fimrware File [How To Flash ROM]

If you have an Evercoss M40 smartphone. And you want Evercoss M40 Firmware to solve your bricked device. then you definitely are in the best article/post. We will guide for you to install the official Evercoss M40 Stock Firmware on the device. This step is simple and straightforward to follow. We have listed the Evercoss M40 Flash File below. Download the Stock ROM file to repair your Evercoss M40.

Evercoss M40 Firmware

This article contains the Evercoss M40 Firmware. That will allow you to recover your Evercoss M40 mobile into its initial Factory state. Additionally, you can use the file to change your phone to the newest version. You’ll find these below files useful if you have used the flashed customized builds on the device. brick your device, change your device and also come back that device to the factory state.

The Benefit Of Evercoss M40 Firmware:

  • Flash Stock To Unbrick your Evercoss M40
  • Flash Stock ROM to solve the boot loop issue
  • Update and Downgrade Evercoss M40
  • Unroot or Fix Bugs on the phone
  • To solve the lag or stutter on Evercoss M40
  • By flashing Stock ROM, you can fix software issues.
  • Revert back to stock to get your warranty.

Evercoss M40 Firmware Details:

  • Gapps File: Included
  • Device Supported: Evercoss M40
  • Tool Supported: SPD Factory Upgrade Tool
  • Processor: SPD
  • Os: Android

M40_EVERCOSS_V14_5.1_17_PAC.rar

Pre-Requirements To Flash Evercoss M40 Firmware:

Evercoss M40 Flashing Tool:

We will use the SPD Factory Upgrade Tool to flash Evercoss M40 firmware. This tool is very efficient. Follow the step by step procedure to use One Click Unbrick Tool and unbrick your Evercoss M40.

Evercoss M40 Driver:

How to install Firmware on Evercoss M40:

  1. Install Spreadtrum Drivers.
  2. Install the SPD Download Tool.
  3. Open the Research download tool > bin folder.
  4. Launch ResearchDownload.exe.
  5. Click on the Load Packet icon (top left corner).
  6. In the window that pops up, navigate to the location of the .pac file, select it then click Open.
  7. The PAC file should now be loaded (its name should appear at the top).
  8. Click the Settings Icon (top left corner).
  9. In the box that pops up, untick any item(s) you do not wish to flash then click OK. Ignore this step if you wish to flash all files.
  10. Click the Start downloading button.
  11. You should see Waiting…. under the Progress bar.
  12. Switch off the phone (still with battery inside) then connect it to the PC via USB cord (note that you might need to hold the volume decrease button while connecting to PC on some phones) and flashing should begin. DO NOT interrupt.
  13. Once flashing is complete, you’ll see Passed.
  14. Click on the Stop downloading icon then disconnect the phone from PC and boot.

Follow Detailed Instruction Evercoss M40 Flashing With Spreadtrum Upgrade Tool.

Disclaimer:

  • Bin Packet load Error: If you ever got Bin Packet Error When Flashing Evercoss M40 then simply download and try flashing the Evercoss M40 firmware with this version of SPD Upgrade Tool.
  • How to Write IMEI: After flashing the Evercoss M40 firmware on Spreadtrum Device, you may need to flash the IMEI also, for that use WriteIMEI on Spreadtrum Devices.

Comments are closed.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More